The company produces in its plant all the semifinished
products necessary for constructing magnetic components, with
intermediate checks being made at every stage of production.
Armatures are built in the metal structural works department
with the aid of machining equipment, and all semifinished
products undergo a mechanical-chemical finishing cycle (tumbling).
The magnetic part is produced starting with three coils with
5 automatic lines for cutting and perforating the magnetic
sheet, which guarantees maximum productive flexibility combined
with excellent cutting quality.
Winding is done using automatic and semi-automatic winding machines,
which can wind wire, magnetic strip and
copper and aluminum strip and bands, including multiple, up
to a coil length of 1200 mm and a coil diameter of 1800
mm.
The semifinished products are assembled in the
assembly department and are sent to the testing room for pretesting.
The impregnation cycle is done in vacuum/pressure autoclaves in
order to eliminate all moisture present and to obtain
the maximum resin penetration, thus guaranteeing limited noise
levels.
Heating in furnaces (2 units) is also done in this department,
with an 8-hour cycle at a temperature of 140°C.
The chemical-physical characteristics of the resin are monitored
continuously, in order to obtain the most consistent
results possible.
Following treatment, the components are sent to the finishing
department and then again to the testing room for final
testing.
MIG - TIG - OXYACETYLENE welding is used during the production
cycle, and is done exclusively by workers
specifically trained for these types of welding.